Change the default company name on your security key

General Forum, Membership and Cabnetware Information
Locked
Jim Diebolt
Posts: 375
Joined: Sun Dec 04, 2016 4:05 pm
Location: Placerville "Hangtown" California
Interests: Woodworking, computers and motorcycle riding
Occupation: Retired cabinetmaker and cabinet designer

Change the default company name on your security key

Post by Jim Diebolt » Thu Nov 21, 2019 11:26 am

Do you want to change the company name that is installed by default on your security key?

I now have a program that will replace the default company name on your security key. That is the company name that shows up on all reports, individual cut list, batched cut list, master cut list, floor plan and elevations when “Print Title Block” is selected, proposals, change orders and others. With this option you will still be able to use the default name by using the original CW icon to open your program. If you use the new icon that I install on your Desktop it will use the new name you have selected for your program.

This option is for members of the forum and will cost you a one-hour tech support fee of $125.00. For this fee you will receive two icons, one Frame and one Euro. If you need only one icon the fee is the same.

This option DOES NOT CHANGE YOUR ORIGINAL SECURITY KEY DEFAULTS. It does changes to your .ini file every time you open your program to fill in the new name you want to use.

Please call me with any questions you may have.
909-851-7972 Mon – Fri 9:00 am to 5:00 pm PST or after hours and leave a message.

Image
Jim Diebolt
V-14 Build 8683
Jim@Designsbydiebolt.com

Image

Locked